Xtar MC1 Charger



In stock

The new MC1 charger has a spring loaded battery bar that can accomodate a range of battery lengths without the need for spacers. I know, awesome.

What you should know about chargers

Chargers are a critical component with respect to lithium ion batteries. Very critical.

Xtar chargers are top notch and the MC1 is a third generation charger. I searched high and low for the best value (performance + price) in a modern charger and this is it. I like the industrial design and this charger has the advantage of being USB based. This means you can plug it into your laptop, use a wall adapter, or even a car adapter for charging. I like this flexibility for a general purpose charger.

If are a hardcore "input" person you can check out Battery University for tons (and tons) of information.


A lot of people ask how long a battery takes to charge. That depends on how deeply the battery is depleted. That said, the MC1 should take no more than 5-6 hours to charge a depleted battery. If it takes a lot longer than let the battery get "too" low.

The MC1 is not a "fast charger," or at least not as fast as some chargers. There are two reasons this is good. First, the charger uses a current of 500mA and this relatively low current makes it possible to charge from a USB port. Second, the AW batteries can be charged with up to 2000mA safely, but charging at high current reduces total battery life span.


In my personal use, I will put the battery on the charger if I've used it for more than 10-20 minutes. At this level of shallow discharge the battery will top up in 40-80 minutes. 

DO NOT leave the battery in the charger for an extended period of time. Overnight is fine. The MC1 has a safety feature to prevent over-charge, but best practice dictates that you should remove the battery when the charge cycle is complete.

The Xtar MC1 has a "charge checking" feature that will periodically check the battery voltage if it's left in the cradle. When the voltage drops below 4.0V the charger will proceed to fill the battery back up to 4.2V. The MC1 will not begin a charge if the battery is above 4.0V.

If you put a battery on the charger and the LED stays green, this means your battery is above 4.0V and ready for use.

Please note, deeply discharging a li-ion battery also reduces its life span.

Unlike other chemistries, li-ion has no "memory effect" so you can charge it any time without loosing capacity. In other words, it's best for battery health to recharge frequently rather than waiting till the battery is "dead."

1) Accurate ending voltage. Li-ion batteries are not capable of absorbing over charge like some other chemistries. This means it's critical that a li-ion battery never exceed 4.2 volts. The information I've gathered from other users is that the MC1 does a good job of ending the charge at, or below, the maximum allowable voltage. In fact, it errs on the slightly low side...often around 4.1 to 4.15 volts. 
Some power users are bothered by the fact that it doesn't charge really close to 4.2 volts. In my opinion, this is an advantage because you trade a couple of minutes of run time for increased battery life span. The closer you charge a li-ion to it's absolute maximum capacity, the more it degrades the battery's total usable life. 
2) Complete charge termination. This (in my opinion) is the most critical feature for a li-ion charger. This means the charge current is FULLY cut off once the battery is charged. The funny thing is, many generic chargers specifically made for li-ion batteries DO NOT have this feature. They continue to apply a small amount of current even after the battery is full. If you cannot absorb over charge. Over charge leads to heat build up and if left unchecked may cause the cell fail catastrophically. In other words, catch fire. 

Woah! Okay I know you might suddenly be thinking li-ion batteries are dangerous. Keep in mind that virtually every modern laptop and cell phone uses li-ion batteries...and this is why having a high quality charger (and batteries) is very important. This is also the reason I won't sell anything but Xtar chargers and AW batteries.

Plug Type USB (500mA)
Charging Channels 1 Channel
Charge Current 500mA
Termination Voltage 4.2V +/- .05V
Charge Profile TC/CC/CV
Supported Batteries Li-Ion 3.7V (spring bar accomodates batteries from 10440 to 26650 size)
Reverse Polarity Protection YES
Where it's Made

Signup for Awesome

Enter your email address for stock alerts, discounts, promotions and more!