Preon Titanium Clip
Shop our instagram gallery
Created by popular demand!
Note: this clip will only fit the older generation Preon pictured in the product image.
Material: We use ASTM Certified Domestic 6Al/4V titanium, which is 50% more expensive than consumer grade titanium, to insure maximum quality and consistency.
This clip is specifically designed for the original 4 Sevens Preon flashlight. It's a little bit longer than the stock clip and MUCH thicker and stronger than the stock clip. Clean and unassuming lines compliment the original design of the Preon.
IMPORTANT (Installing your clip)
- First, the o-ring must be removed to install the clip. Replace the o-ring after installation.
- Second, the clip will scratch the anodize finish if it's allowed to rotate during installation.
- If you scratch your light during installation you didn't read the bold-red heading.
I have recently switched over to anodizing my Ti clips. This process uses electricity instead of heat to develop the oxide layer. This oxide layer refracts light at different wave lenths and can present different colors, kind of like oil on water. I offer two versions: Prometheus Blue (above left) and Faded (above right). I do not offer other colors, or custom colors at this time.
What used to be a sheet of solid titanium (below). Waterjet is really an amazing technology. For those of you that don't know, the machine literally uses a stream of water (laden with garnet abrasive) to cut the material. You know, like a waterpik that you clean your teeth with? Like that, but bigger. A large waterjet machine will cut up to 6 inches of solid steel (or granite) or anything else you put underneath it. That makes me giddy just thinking about it.
|Clip Dimensions||OD =.5" / ID= .435"|
|Clip Material||Aerospace Certified 6Al/4V Titanium|
|Where it's Made|